16 Pin Replacement Cartridges for A6S Ultima Microneedling Pen (A Pack of 10)

16 Pin Cartridges for Dr. Pen A6s – General Facial Rejuvenation
The 16-pin cartridges are suited for full-face treatments and provide a more comfortable and balanced microneedling experience. They are ideal for addressing fine lines, mild scarring, pigmentation, enlarged pores, uneven skin texture and overall skin rejuvenation. 

Here is the cartridge selection guide for more information.  

What's Included:

• 1 pack of 10 x 16-pin Microneedle Cartridges, compatible with the A6S Microneedling Pen.

The needles are made of high quality surgical stainless steel and titanium. The 16 pin cartridge head suits smaller areas better and is unique to the A6S model. The 16 pin cartridge features the finest needle gauge at 0.18mm thickness, which allows for precision skin application.

Please note: Ensure to use a new needle cartridge each time you microneedle. 

Important: Microneedling cartridges must be sterilised before each use to ensure the treatment is safe and hygienic. It is essential to follow these steps carefully to ensure that the microneedling cartridges are properly sterilised. Here are the steps to sterilise microneedling cartridges:

1. First, ensure that you have all the necessary equipment for sterilisation; gloves, isopropyl alcohol solution (70% or above) and a clean container to hold the solution.
2. Put on your gloves to avoid contaminating the cartridges during the sterilisation process.
3. Check on your cartridge; ensure the needles are in perfect condition (i.e. not bending) and remove any debris.
4. Pour enough alcohol solution into the container and dip the cartridge needle into a sterilisation container, then soak for a couple of minutes.
5. If you have alcohol solution in a spray model, you can spray it towards the needle head of the cartridge.
6. Once the sterilisation is complete, allow the cartridge to air dry before using it.
7. Finally, your cartridge is ready for use.

How to Use

• To ensure there is no cross-contamination, cartridges must be sterilised before treatment.
• Double-cleanse (cleanse and repeat) then wipe the skin clean. Fully tie back your hair, away from your face. 
• Work in small areas and apply serum to each area before needling. This will help to ensure that the pen does not drag or pull on the skin. The recommended pattern to move the pen for best results is vertical, horizontal, and then diagonal in both directions. Using a light pressure and without dragging, repeat this motion over each area two times.

DO NOT USE

• On open wounds. 
• On active acne or irritated skin. 
• If irritation occurs.
• 16-pin cartridges are not suitable for hair loss

Use up to a maximum of 1mm. Refer to the Dr. Pen Needle Depth Guide. Please speak with your doctor before purchasing any Dr Pen products. The content on this site is not intended to substitute for the advice of a qualified physician, pharmacist, or other licensed health-care professional. The products may have additional information and instructions on or inside the packaging that you should carefully read and follow. Contact your health-care provider immediately if you suspect that you have a medical problem. This product may not have been evaluated by the Food and Drug Administration and is not intended to diagnose, treat, cure, or prevent any disease or health condition. For any concerns or questions, please contact your GP or dermatologist.